Storage, Repair parts, Motor, switch & drive detail – Sears 247.8829 User Manual
Page 8: Trouble shooting chart
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
![background image](/manuals/718248/8/background.png)
STORAGE
It unit i$ to be stored over 30 days, prepare for storage as
follows:
1, Remoi'e all dirt from exterior of unit.
2. Block the unit up so that it is not resting on the rubber auger
paddles.
NOTE: Store your snow thrower in a clean, dry, well ventilated
area to avoid rust and deterioration during storage.
TROUBLE SHOOTING CHART
WARNING: Disconnect power supply cord before
attempting any remedy.
DOES NOT
START
1. R* $ura thaï th» avlanston cord ¡i pluggad iruo tha outlol
and ih* snow iivow«! switch plug,
2 Choch to saail a I
usd
has baan blown or a ctrcuhbiaaKor
tupped IP your BlaCtticaJ boi,
3. Ba
sura switch lavar Is in tull tun posil«y>.
EXCESSIVE
VIBRATION
ChocK lor da mag od or loose pahs. H vbiai'ion persists,
haue the snow ihrCMer and rnotor checked by you> nearest
Authorized Service Dealer betöre cornlnuing to use.
APPARENT LOSS
OF POWER-
MOTOR STALLS
1
.
Chadtiot snow and Ice ecoimulalionaiOurKl all moving
parts.
2. Clean Inside ol auger housing.
POOR SHOW
DISCHARGE
1.
Clean
auger houstng
and
Chule area.
2. Check loi eicasstveiy worn or damaged eugw.
SEARS CRAFTSMAN 21" ELECTRIC SNOW THROWER MODEL NO. 247.882900
REPAIR PARTS
MOTOR, SWITCH & DRIVE DETAIL
SWITCH DETAIL
Pages