Wiring connections, Lamp installing or replacement, Filter installation and replacement – Sears 233.52053 User Manual
Page 5: Maintenance, Filters, Cleaning
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WIRING CONNECTIONS
AJl wiring connections must comply with local codes and the unit
must be properly grounded.
1. Make sure box connector is secure.
2. Refer to FIGURE 8. Make wiring connections.
3. Replace electrical box cover and secure with screw.
LAMP INSTALLING
OR REPLACEMENT
1. Depress sides of light diffuser until tabs of diffuser disengage from
slots in hood. Remove diffuser.
2. Install (2) 40 watt maximum,TypeA-15 appliance bulbs.
3. Replace difuscr in hood by depressing sides and engaging tabs in
slots in hood.
FILTER INSTALLATION
AND REPLACEMENT
1. For ducted opetation, install the aluminum mesh filter. For non
duct operation, install the non-ducted filter (Model 50190, sold
separately).
2. Refer to FIGURE 9. The filter slides into channels at the back of
the hood, on either side of the fan compartment, and snaps under
the spring clips near the front of the Ian compartment.
MAINTENANCE
FILTERS
IMPORTANT: The aluminum filter should be removed once monthly
and washed in hot detergent water. Rinse in clear, warm water and
shake off excess moisture before replacing. The filter may also be
cleaned in your dishwasher.
IN A NON-DUCTED INSTALLATION: Replace filter every 3-6 months
as needed.
CLEANING
The hood should be wiped off occasionally both inside and outside
using warm water, mild dish detergent and a soft cloth. Never use
scouring powders, steel wool pads or any other abrasive cleaners
which will destroy the hood’s finish.
CD
z
E
Q
O
O
Z
WHT
BLK
GREEN G
round
SCREW^
d?
WHT
BLK
GREEN
OR BARE
(GROUND)
CO
c
■o
■o
r
■<
§
31
z
o
FIGiniE 8