Control panel, Setting the timer, Programmed mode – DeLonghi PAC 02 User Manual

Page 10: Non-programmed mode, Air-conditioning, Switching off

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

CONTROL PANEL

ONiOFF

pilot light

Tirner ofi/oit pilot light

“Alarm" pilot light

L J

A © ®

ON/OFF

bullon

tinner ON/OFF

button

1“:—~

3) - 0»

Selaoting Ian

epeocJ button

Tirner notches

Thermostat knob

SETTING THE TIMER

The programmer/timer, like all clacks, must be
set to the exact time. It for example it is 4 00

p.m , turn the dial in a clockwise direction (fol
lowing the direction of the arrow) until the num
ber 4 is lined up with the arrow pointer (the
arrows indicates 4:00 p.m, approximately).

Note;

Never turn Ihe dial in an anti-clockwise

direction!

The timer is in effect, an electric clock and

works only if the plug is connected to the power

supply. Whenever the plug is disconnected or

there is a power failure, the programmer stops

(the clock IS then “slow"'} and must be re-set.

The unit can be used in either programmed or

non-programmed mode.

PROGRAMMED MODE

1) Press the timer ON/OFF button.

Set the operating times by pushing out the not

ches on the dial corresponding to the period

required {each notch represents 15 mins.).

Check that the timer indicates the correct

time (see instructions on setting).

The unit will now switch on and off each

operating lime

o.g. irom 9 to 11 a.m.

)

day at the selected times.

Note: To override the programmed operating

times, simply release the ON/OFF key.

NON-PROGRAMMED MODE

I) TIMER ON/OFF button must be released

AIR-CONDITIONING

. Press the ON-OFF

button (J) to

start the

appiiance.

2. Set thermostat knob at max. cold.

Choose desired temperature. For universal consumer convenience, the temperature is shown

by spaced marks rather than in degrees. It is recommended that the thermostat be placed on
max. cold until room temperature has reached the desired level of comfort, then slowly turn the
thermostat knob clockwise until the thermostat shuts off the compressor while ventilation conti
nues, In so doing, you wilt have programmed your appliance on to this exact level of comfort

which the thermostat will automalicaly maintain After an initial period of use, consumers will be

able to judge immediately the required setting for reaching the temperature desired in a room.

SWITCHING OFF

1 To turn the the appliance off, press ON/OFF button CD

With The appliance on cooling, air humidity in Ihe room is automatically reduced and condensate
eliminated through the exahust hose