Philips Hair clipper QC5130 With adjustable comb - Manual (Page 7)

n
Remove the hair clipping comb by pressing
and sliding the Hair Length Selector upwards
(fig-7).
Be careful when you are clipping without comb
attachment as when the Clipper is turned on it
will remove every hair it touches.
B To contour the hairline around the ears,
comb the hair ends over the ears.
H Tilt the Clipper in such a way that only
one edge of the cutter blades touches the
hair ends when you shape the contours
around the ears (fig. 8).
Only cut the hair ends.The hairline should be
close to the ear
Q To contour the nape of the neck or
sideburns, turn the Clipper and hold it with
the cutter blades pointing downwards
(fig-9).
B Move the Clipper slowly and smoothly
following the natural hairline.
Clipping without hair clipping comb
Cleaning
i
Clean the attachments after each use.
I Always switch Clipper OFF, unplug and remove
power supply cord from Clipper before
cleaning.
I Do not use compressed air, abrasive cleaning
agents, scourers or liquids such as alcohol,
benzene, bleach or acetone to clean the
Clipper and attachments.
k Never clean, replace or remove Clipper
attachments with motor ON.
I Never rinse or immerse the Clipper in water
or any other liquid.
i
Do not apply pressure to cutters.
I Do not touch cutters with hard objects as this
may damage them.
i
Use a soft, dry cloth to clean Clipper handle.
During Use:
k If cut hairs have accumulated in the comb
area, remove hairs by shaking, blowing or
using cleaning brush provided. Remember to
adjust the clipping length back to your selected
setting when you replace the comb on Clipper.
After Each Use:
n Make sure the Clipper is switched OFF
and disconnected from the electrical outlet.
B
Remove the hair clipping comb by pressing
and sliding the Hair Length Selector upwards
(fig-7).
H Blow and/or shake out any hair that may
have accumulated in the hair clipping comb.
Q Push the middle part of the cutter
blade upwards with your thumb until it
opens (fig. 10).
B
Clean the cutting unit with the brush
supplied (fig. 11).
□ Clean the inside of the Clipper with the
brush supplied (fig. 12).
B
Clean the handle and the adapter with the
cleaning brush supplied or with a dry cloth.
NOTE:The Clipper does not need any lubrication.