Philips G390-60 - Manual (Page 10)

Table 3. Hair Clipper
Setting Remaining hair length
(in)/(mm)
Ooiel^ Cropped .18 m 74 mm
Short ia/ 6 mm
3 Medwm y>ort .31 m/ 8 mm
Medium 39 in/lOmm
5 Medum Long .47 n/l 2 mm
6 Long 55 m/l 4 mm
7 Longer .63 ia/l 6 mm
8 Extra Long .71 vUISnvn
9 Longest 79 ix/ 20 mm
Q Make sure that the flat part of the comb is
always in full contact with the scalp to obtain
an even result.
□ Move the appliance slowly over the crovm
from different directions to achieve an even
result (fig. 28).
D
Always move the appliance against the
direction of hair growth.
□ Make overlapping passes over the head to
ensure that all hair that should be cut has
been cut
□ Turn the Groomer off and remove the hair
comb often to blow and/or shake out hair
that has accumulated.
I REMEMBER:You must reset the hair length
selector back to your desired setting every
time you replace the hair clipping comb on the
appliance.
Contouring without the hair clipping
comb attachment
D
Remove the hair comb by pressing and
sliding the Hair Length Selector upwards
(fig. 29).
Be careful when you are clipping without comb
attachment as wlWn the appliance Is turned on it
will trim every hair it touches.
Q Tilt the appliance in such a way that only
one edge of the trimming attachment
touches the hair ends when you shape the
contours around the ears (fig. 30).
□ To contour the nape of the neck, hairline, or
sideburns, turn the appliance and hold it with
the trimming attachment pointing downwards
(fig. 31).
□ Move the groomer slowly and smoothly
following the natural hairline.