Switching the set on and off, Adjusting volume and sound, Radio - tuning to radio stations – Philips AZ1207-17 User Manual

Page 9: Basic functions radio

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

BASIC FUNCTIONS

RADIO

Switching the set on and off

Set the POWER control to the desired sound source:

CD, TUNER, or TAPE.

The set is switched off when the POWER control is set to

OFF/TAPE and the keys of the tape deck are released.

Note: If you use batteries, always be sure to switch the set off

after use. This will avoid unnecessary power consumption.

Adjusting volume and sound

Adjust the volume using the VOLUME V A control.

— Display indication: Volume level from 0 to 32.

Increase and decrease the bass level by pressing DBB.

Switch the surround sound effect on and off by pressing

INCREDIBLE SURROUND.

The bass level can also be emphasized if you place the set against

a wall or shelf. Do not cover any vents; leave sufficient room

around the unit for ventilation.

Note: The effect of INCREDIBLE SURROUND may vary with

different types of music.

Radio - tuning to radio stations

Set the POWER control to TUNER.

2 Select the wave band using the BAND selector.

3 Tune to the desired radio station by using the TUNING knob.

Improving RADIO reception

For

FKI

stations, pull out the telescopic antenna. To improve the

signal, incline and turn the antenna. Reduce its length if the signal

is too strong (very close to a transmitter).

For

stations, direct the built-in antenna by turning the whole

set. The telescopic antenna is not needed.