Wingscapes Wildlife Cam - Manual (Page 8)

Page 8
WildlifeCam User Guide
Page 9
WildlifeCam User Guide
Setting Multi-Shot
Press the OK button. Use the Up/Down buttons to choose between settings. Choose how
many pictures you would like captured in a sequence when the camera is triggered (1 or 3).
Available options are:
1 (OFF) - Single photo taken per event.
3 BURST - Three rapidly captured photos taken per event. All 3 photos are captured within
one second.
NOTE: Burst mode is only capable of up to 4MP captures, regardless of your resolution
setting.
3 TRIGGERED - Up to three photos are captured per event with an approximate one second
delay between each capture. Each subsequent photo after the first requires an individual
trigger. This allows for multiple potential image captures of the same event while reducing the
chance of empty images if the subject moves out of the field of view after the first shot.
Press OK to lock in your selection, then press Right button to go to the next option.
MULTI-SHOT
1 (OFF)
UPGRADE FIRMWARE
WLIFE-131007 NO
Upgrade Firmware
The firmware version is displayed. Press Up/Down to choose setting.
YES - To upgrade firmware.
NO - Keep current firmware.
Make sure that an SD card with the new firmware is inserted into the camera. Press the
OK
button to make selection. Make sure the process is completed before pressing other
buttons or powering the camera Off. Press the Right button to move to the next option.
PROGRAM SECURITY
CODE 00000
Security Code
Press the OK button. Use the Up/Down and Left/Right buttons to select a 5 digit security code
for your camera. Press the OK button to confirm the selection. Press the Right button to move
to the next option.
NOTE: Please remember your security code. If the code is lost, you can contact
Wingscapes customer support to reset the password (charges may apply). Also, use
caution when navigating through the Security Code option as not to set a code by
mistake. For no Security Code, the setting should remain as “00000”.
Imprint Info?
Use the Up/Down buttons to choose between:
YES - Camera Name, Time, etc, information will be imprinted at the bottom of the image/
video as an information bar
Note: Remember to input the camera name in the setup and set the clock accordingly.
NO - No information bar will be imprinted.
Press the OK button to confirm the selection. Press the Right button to move to the next option.
IMPRINT INFO?
YES
CAMERA NAME
WILDLIFECAM
Setting Camera Name
Press the OK button. Use theUp/Down and Left/Right buttons to select an identity for your
camera. For example, you can use a name or a location; the identity you wish to use is up
to you. Press the OK button to confirm the selection. Press the Right button to move to the
next option.
WI-FI SD CARD?
NO
Wi-Fi SD Card
Select option when using a Wi-Fi enabled SD card. Turning this feature on will keep the SD
port powered for a set amount of time to allow the files to transfer off the card to the Wi-Fi
network set up.Press the OK button to confirm the selection. Press the Right button to move
to the next option.
NOTE: Wingscapes does not offer technical support for Wi-Fi SD cards. Please contact your
Wi-Fi card’s manufacturer for support. Before use, you must set up your Wi-Fi SD card on
your wireless network.
NOTE: Use of a Wi-Fi SD Card will decrease the battery life of the camera.
AC CONNECTED?
NO
AC Connected
Press the OK button. When the camera is connected to an AC power supply and this option is
selected, the camera will remain on instead of going to a sleep state between detection and
capture sequences. This will greatly improve camera speed and performance and can be used
in conjunction with most external supplies, but is only recommended when connected to an
AC power supply. In the event this option is selected but no external supply is detected, it will
default to the NO state. Press the OK button to confirm the selection. Press the Right button
to move to the next option.