Winco 25PTOC-3 - Manual (Page 6)

Page 4 60706-199 1005-00
ELECTRICAL CONNECTIONS
CAUTION:
Only qualified electricians should install electrical wiring.
Wiring must conform to all applicable national, state, and local
codes. (Reference: National Fire Protection Association
Manual No. 70, National Electrical Code.)
DANGER: PERSONAL INJURY
IF THE GENERATOR IS TO BE USED AS A STANDBY
POWER SOURCE, A SPECIAL DISCONNECT SWITCH
MUST BE INSTALLED TO SEPARATE THE GENERATOR
AND THE COMMERCIAL POWER LINES. THE
DISCONNECT MUST ISOLATE THE GENERATOR FROM
THE COMMERCIAL POWER LINES AND THE LOAD WHEN
THE GENERATOR IS ON STANDBY, AND MUST ISOLATE
THE COMMERCIAL POWER LINES FROM THE LOAD AND
THE GENERATOR WHEN THE GENERATOR IS SUPPLYING
POWER. SEE FIGURE 5.
Typical Connection Methods for Generator Power Service Figure 5