Use and operation, Installing in a vacuum system, During operation – VACUUBRAND SKF H 40 User Manual
Page 7: Maintenance and cleaning
Documents are only to be used and distributed completely and unchanged. It is strictly the users’ responsibility to check carefully
the validity of this document with respect to his product. Manual-no.: 999229 / 03/08/2009
page 7 of 7
Alfred-Zippe-Str. 4 - 97877 Wertheim
Tel.: +49 9342 808-0 - Fax: +49 9342 808-450
E-Mail: [email protected] - Web: www.vacuubrand.de
Installing in a vacuum system
➨
Assemble the cold trap at a stand mounting.
➨
Connect the cold trap to the vacuum pump and the recipi-
ent.
☞
Prevent mechanical stress at the connection due to tensile
force or vibrations.
➨
Close the condensate drain screw.
During operation
➨
Fill coolant into the coolant chamber.
☞
Check coolant level at appropriate intervals.
➨
Switch on the vacuum pump immediately after filling in the coolant.
☞
The coolant consumption is increased if the condensate chamber is not evacu-
ated
☞
The lifetime of the coolant may be restricted due to icing in case of high operating
pressures.
➨
Vent the cold trap for de-icing or draining of condensate.
➨
Drain condensate via the condensate drain screw. Vent the system prior to open-
ing the drain screw!
☞
Wait until the condensate has liquidised, if necessary.
☞
Ensure that condensate drain tubing and collecting equipment are chemically re-
sistant against the condensate.
☞
Remove the cold trap from the vacuum installation to drain the coolant if neces-
sary.
Use and operation
Maintenance and cleaning
☞
The cold trap is maintenance-free.
☞
Clean the cold trap, coolant chamber and the condensate chamber using water
or solvent. Ensure compatibility of the wetted parts!
☞
Comply with applicable regulations when disposing of solvents.
VACUUBRAND GMBH + CO KG
-Technology for Vacuum Systems-
©
2009 VACUUBRAND GMBH + CO KG Printed in Germany