CLIFFORD concept 20 - Manual (Page 6)

Standard Features of the Concept 20 (cont.)
✔ Remotely Adjustable Dual-Zone Piezo Sensor™ — With just a touch on the
remote, you may, at any time or place, adjust and test the sensitivity of
this microprocessor-controlled solid-state sensor. The two sensor zones
provide full perimeter protection: If someone bumps into your car, the
system will sound a distinctive warning tone; if forced entry is detected,
the full alarm will sound.
Audible Confirmation of Sensor Adjustments — Issues two chirps for
each incremental increase and a single chirp for each incremental
decrease in sensitivity.
Unprecedented Reliability — There are no moving mechanical parts to
wear out and the entire electronic circuitry resides in the passenger
compartment, not in the engine well where it would be exposed to
temperature extremes, water, vibration and dirt.
Adjust and Test Unobtrusively — No repeated arming and disarming,
and no siren wailing. You set and test sensitivity without activating the
alarm!
✔ Dual-Mode “Chirp” Silencing —Whenever you remotely arm or disarm,
the siren “chirps” and the parking lights flash to confirm system status.
Whenever you wish, you may silence the chirps with either of these two
methods:
Remote Controlled Chirp Muting —Just a press of remote control
button 3 will arm and disarm the system silently. It’s perfect when
parking at night in a quiet residential area.
Long-Term Chirp Silencing —A few flicks of a switch silences the
chirps until you choose to reactivate them.
✔ Remote Controlled Courtesy Lighting —For your personal safety and
convenience, when you remotely disarm your Concept 20, the interior
lights turn on and stay on until you start the engine or 30 seconds,
whichever occurs first.
✔ Built-In Parking Light Flasher —Visually confirms door lock and system
status.
4