TYREDOG TD-1300A-X4 User Manual
Page 22
21
Sleep Mode
As previously mentioned on page 17, the Tyredog monitor has a built in
vibration sensor which is used to switch power. If the unit is left still for 15
minutes, it will automatically turn off. This also eliminates the need for a
power switch, which helps minimize the size of the monitor. If the monitor
receives any vibration or a button is pressed, it will automatically power up
to its previous state.
If a battery is inserted to a non learnable existing sensor whilst the monitor is in
learning mode, the monitor will beep 3 times to indicate that it’s not a learnable
code. If you hear 3 beeps with your learnable sensor, please contact your
reseller to obtain a replacement.
Note: it is normal for sensors to take some time to initiate. If no beeps are heard
when the battery is inserted, wait a few moments.