Care and cleaning – Twin Eagles TEOR24-C User Manual
Page 8

8
CARE AND CLEANING
Condenser Air Flow
The machine compartment located beneath the cabinet does
not require frequent cleaning; however, sati sfactory perfor-
mance depends on adequate venti lati on. Be sure nothing ob-
structs the required air fl ow openings in front of the cabinet. At
least once or twice a year, brush or vacuum lint and dirt from the
front grille openings.
Cabinet and Door
The stainless steel cabinet and door can be cleaned with a stain-
less steel cleaner and a soft cloth. NEVER use abrasive scouring
cleaners, rough cloth, or cleaning pads.
Interior and Door Gasket
Wash interior compartment with mild soap and water. You can
also use a soluti on of 2 tablespoons of baking soda to 1 quart
of warm water. Do NOT use an abrasive cleaner, solvent, polish
cleaner or undiluted detergent.
Care of Unit
1. Avoid leaning on the door, you may bend the door hinges or
ti p the unit.
2. Exercise cauti on when sweeping, vacuuming or mopping
near the front of the unit. Damage to the grille can occur.
3. Periodically clean the interior of the unit as needed.
4. Periodically check and/or clean the front grille as needed.
In the event of a power failure
Minimize the number of door openings to prevent a gradual rise
in temperature while the power is off .
Help Prevent Tragedies
Each year children die because they climb inside a discarded
refrigerati on product, get trapped inside, and suff ocate. Take
precauti ons to prevent such tragedies by removing the door or
by taping or chaining it shut before discarding.
Light Bulb Replacement
DISCONNECT THE POWER CORD BEFORE ATTEMPTING LIGHT
BULB REPLACEMENT. Failure to do so may result in an electrical
shock that could severely injure you.
The refrigerator uses one, 15 watt incandescent light bulb to
illuminate the interior of the refrigerator. The light bulb is a very
reliable electrical component, but should it not functi on proper-
ly, please call the dealer where you purchased your refrigerator
from for a replacement light bulb. Use only an original equip-
ment light bulb from your dealer or Twin Eagles.
Do NOT under any circumstance use a light bulb that exceeds 15
watt s!
To replace the light bulb, disconnect power to the unit. Unscrew
the old light bulb located behind the display housing at the top
of the unit. Set the old light bulb aside. Screw the new light
bulb into place. Reconnect power to the unit. Check to see if the
light bulb operates properly to complete the installati on.
The light bulb is not covered by your warranty. A replacement
bulb can be obtained from your dealer or from Twin Eagles.