Twin Eagles TECG30-B - Manual (Page 6)

ASSEMBLY INSTRUCTIONS –
T WIN E AGLES C HARCOAL G RILL
The
T WIN E AGLES Charcoal Grill is produced fully assembled and tested in the factory and
requires no major assembly in the field. For the purpose of safe shipping and transit, some parts are
wrapped inside the grill and require minor assembly.
Check to ensure that all packaging material has been removed prior to grill operation.
TO INSTALL THE CRANK HANDLE
1. Open the front access door and locate the nut
on the inside right hand behind the front panel.
2. Slide the threaded part of the crank handle
through the hole on the front panel and screw it
into the nut inside the firebox body.
Optional Rotisserie Kit (Note: can be installed on either left side or right side)
1. Install the rotisserie motor as shown. (See fig. 1) The motor socket hole will line up with the
hole on the side of the rear hood.
2. Insert the hex end of the rotisserie rod through hole on right hand side of the rear hood.
(See fig. 2)
3. Then insert the rotisserie rod into to the motor socket hole. (See fig. 1)
WARMING RACK
Install the warming rack as shown.
When the warming rack is not in use, it may be moved out
of the way by sliding it out forward towards the front of
grill.
3
Front Access Door
Nut Crank
Fig. 1 Fig. 2 Installed Rotisserie Kit
2