Triner Scale TP-10 User Manual
Page 4

“CE” logo here somewhere…
Getting Started
1. After removing scale from carton, pull out the cardboard protection that is located be-
tween the platter and the scale enclosure. Do not remove the platter – simply pull
out the cardboard protection and discard.
2. Plug the supplied AC Adapter into the scale first, then into an AC outlet. For portable
operation, install 6-AA size alkaline batteries (not included) into the battery compart-
ment located underneath the scale. To install batteries, remove the compartment cover
on the underside of the scale, fit the 6 AA batteries in the spaces provided (observe po-
larity markings) and re-engage the cover clips.
3. Place the scale on a stable and firm table.
4. Press the ON (9) key to begin the initialization.
Push clips and pull to
Remove compartment cover
Observe battery polarity (+/-)
Initialization –
When the scale is switched ON for the
first time, the scale will display some in-
formation and then prompt you for the
origination ZIP Code. Your origination
ZIP code is the ZIP code from which
you will mail or ship items. This step is
vital to obtaining the correct postal
rates from your scale.
Enter the first three digits of your ZIP Code. For example, if your ZIP code is 60089, then
you would enter 600.The scale displays the ZIP Code entered and then resumes normal
operation.
NOTE: The scale displays the origination ZIP code as part of its start up sequence. To ver-
ify your origination ZIP code, switch the scale OFF and then ON again. Then look for the
numbers that appear after the ”oZIP_” message.
2