Traxxas 6308 (DR-1 Dual Rotor Helicopter) - Manual (Page 4)

4 • TRAXXAS
Getting Started
1. Read all safety precautions.
2. Charge the battery pack.
3. Install the included AAA alkaline batteries into the transmitter.
4. Install the battery into the helicopter (A).
Make sure the power switch is off.
5. Plug the battery into the power
connector on the model (B).
6. Turn on the transmitter.
Make sure the throttle stick
is in the full down position
(throttle off) (A), then turn the
transmitter on (B).
7. Turn on the model. See
“Flying Your Model.”
T X R X
M1 M2 Expert
OFF
A A
B
T X R X
M1 M2 Expert
OFF
A A
B
The Mode 1 or Mode 2 control positions are set at the factory and are not user-selectable.
The mode is set according to the control configuration that is most common in your
region. Typically Mode 2 is used in the US. The control positions for Mode 1 and Mode 2 are
identical except for the Throttle and Forward / Reverse controls as illustrated above. Be certain
to confirm your transmitter’s mode and refer to the correct illustrations in this manual.
Elevator Trim
Mode 1
Indicator
Rudder
Trim
Throttle
Trim
Expert Mode
Indicator
Aileron Trim
Battery Level
Indicator
Data Display
Elevator Trim
Mode 2
Indicator
Rudder
Trim
Throttle
Trim
Expert Mode
Indicator
Aileron Trim
Battery Level
Indicator
Data Display
A
B
Mode 2 Display Mode 1 Display
Mode 2 Mode 1
OFF ON