Traxxas 55077-1 - Manual (Page 9)

JATO 3.3 • 9
TRAXXAS TQ i RADIO SYSTEM
Your model is equipped with the TQi 2.4 GHz transmitter with Traxxas Link Wireless Module. The transmitter has two channels
for controlling your throttle and steering. The receiver inside the model has 5 output channels. Your model is equipped with two
servos and a receiver.
JATO 3.3 WIRING DIAGRAM
Jato has a provision for
a built-in charging jack
so you do not have to
remove the battery pack
from the model. The wire
for the charging jack is
supplied with the factory
harness, and is stored
inside the receiver box.
It is not installed in the
charging jack to prevent
inadvertently charging
alkaline batteries.
Never use the charging
jack with the 4-cell battery
holder. The charging jack is
for optional rechargeable
5-cell nickel metal hydride
(NiMH) batteries only. See
page 10 for more details.
Channel 1* - CH1
Steering Servo - CH1
Throttle Servo - CH2
Channel 3* - CH3
From Voltage/Temp Senor Port - CH4
Battery - BATT/CH5
RPM Sensor Port - RPM
Voltage/Temp Senor Port - V/T
* Not used
Antenna
On/Off
Switch
Receiver
4-Cell
Battery Holder
Channel 1
Steering Servo
Channel 2
Throttle Servo
RPM Sensor
Telemetry
Voltage Wire
Connects the V/T
port to any open
receiver port.
TRANSMITTER AND RECEIVER
Steering
Trim
Shift
Switch
Throttle
Trigger
Multi-Function
Knob
Throttle Neutral
Adjust
Steering Wheel
Power Switch
Battery Compartment
Traxxas Link
Wireless Module
Set Button
Menu Button
Red/Green Status LED
see page 36 for more info
Link
Button
LED
Sensor Expansion
Port