beautypg.com

Traxxas 56087-1 User Manual

Page 24

background image

24 • E-REVO BRUSHLESS

MOTORS AND GEARING

CAUTION: Read before operating your
model with 65+mph gearing!
• The 24/54 ratio for use with 6S LiPo batteries is designed

for maximum speed on smooth surfaces only, with steady
acceleration to full throttle.

• Do not use this gear ratio for general driving.
• Avoid repetitive starting and stopping.
• Do not use the 24/54 ratio with NiMH batteries or low-capacity

LiPo batteries. 5000mAh LiPo batteries are recommended.

• Allow the motor to cool between runs, and monitor motor

temperature.

• Do not use the 24/54 gear ratio for off-road running or

overheating and damage may result.

• Do not allow the motor temperature to exceed 200° F or damage

and motor failure may result. To accurately monitor motor
temperature and prevent overheating, a telemetry temperature
sensor (part #6521) is included with your model. The sensor is
installed on the motor to continually monitor temperature as you
drive. See page 31 for more information on real-time telemetry
and TQi advanced tuning.

Adjusting Gear Mesh
Incorrect gear mesh is the most common
cause of stripped spur gears. Gear mesh
should be checked and adjusted anytime
a gear is replaced. Access the gears by
removing the single screw on the top
gear cover.

To set the gear mesh, cut a narrow strip of
notebook paper and run it into the gear
mesh of the motor. The motor is mounted
to an aluminum motor mount.
Loosen the single motor mount
screw with the provided 3mm
wrench to slide the motor
mount. Slide the motor and
pinion gear into the spur gear.
Retighten the motor mount
screw and then remove the
strip of paper. You should be
able to run a fresh strip of paper
through the gears without binding them.

Gearing Compatibility Chart:
The chart below shows a full range
of gear combinations. This does NOT
imply that these gear combinations
should be used. Over-gearing
(bigger pinions, smaller spurs) can
overheat and damage the motor
and/or speed control.

BASIC TUNING ADJUSTMENTS

54

56

58

62

65

68

12

4.50 4.67 4.83 5.17 5.42 5.67

13

4.15 4.31 4.46 4.77 5.00 5.23

14

3.86 4.00 4.14 4.43 4.64 4.86

15

3.60

3.73 3.87 4.13 4.33 4.53

16

3.38 3.50

3.63 3.88 4.06 4.25

17

3.18 3.29 3.41

3.65 3.82 4.00

18

3.00

3.11 3.22 3.44

3.61 3.78

19

NR

NR

3.05 3.26 3.42 3.58

20

NR

NR

NR

3.10 3.25 3.40

21

NR

NR

NR

NR

3.10 3.24

22

NR

NR

NR

NR

NR

3.09

23

NR

NR

NR

NR

NR DNF

24

NR

NR

NR

NR

NR DNF

25

NR

NR

NR

NR

NR DNF

Pinion Gear

Spur Gear

Stock gearing

B

Optional included gearing (4S LiPo)

B

Recommended gearing
for 4S LiPo only

Not recommended

Does not fit

Recommended gearing
for all battery types

Motor Mount

Screw

Strip of Paper

Speed

35+ mph

40+ mph*

50+ mph

65 mph

& Beyond

Pinion/Spur

18/65

18/54

18/65

24/54**

Battery

Twin 7-Cell NiMH

(14 cell total)

Twin 2S LiPo

(4S total)

Twin 3S LiPo

(6S total)

Twin 3S LiPo

(6S total)

Nominal Voltage

16.8V

14.8V

22.2V

22.2V

mAh

4000+ mAh

5000+ mAh

5000+ mAh

5000+ mAh

Skill Level

Your Battery Selection and Pinion Gear
Selection Determines Your Speed.

How Fast Do You Want To Go?

For Expert Drivers

For Expert Drivers

*with included optional gearing
**optional gearing (not included)

Model #56085