Tools, supplies, and required equipment, Decorating your model, Required equipment – Traxxas 70054-1 User Manual
Page 5: Supplied tools and equipment, Applying the decals
1/16 SLASH 4WD • 5
TOOLS, SUPPLIES, AND REQUIRED EQUIPMENT
Your model comes with a set of specialty metric tools. You’ll need to purchase other items, available from your hobby dealer, to operate
and maintain your model.
REQUIRED EQUIPMENT
(sold separately)
Recommended Equipment
These items are not required
for the operation of your
model, but are a good idea to
include in any R/C toolbox:
• Safety glasses
• Traxxas Ultra Premium Tire
Glue, Part #6468 (CA glue)
• Hobby knife
• Side cutters and/or needle
nose pliers
• Phillips screwdriver
• Soldering iron
For more information on
batteries, see Use the Right
Batteries on page 11.
SUPPLIED TOOLS AND EQUIPMENT
2.0mm “T” wrench
4-way wrench
2.5mm ball driver wrench
1.5mm “L” wrench
Body clips
6-cell 2/3A NiMH battery
TR
AX
XA
S
NiMH battery charger
APPLYING THE DECALS
The main decals for your model
have been applied at the factory.
Additional decals are printed on
self-adhesive clear mylar and are
die-cut for easy removal. Use a
hobby knife to lift the corner of a
decal and lift it from the backing.
To apply the decals, place one end
down, hold the other end up, and
gradually smooth the decal down
with your finger as you go. This will
prevent air bubbles. Placing both
ends of the decal down and then
trying to smooth it out will result in
air pockets.
Look at the photos on the box for
typical decal placement.
DECORATING YOUR MODEL
9
4 AA alkaline
batteries