beautypg.com

Quick start: getting up to speed – Traxxas 72074-1 User Manual

Page 7

background image

1/16 SUMMIT VXL • 7

The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom
corners of Quick Start pages.

1. Read the safety precautions on page 4

8. Range test the radio system • See page 14

For your own safety, understand where carelessness and misuse
could lead to personal injury.

Follow this procedure to make sure your radio system works properly
at a distance and that there is no interference from outside sources.

2. Charge the battery pack • See page 11

9. Detail your model • See page 5

Fully charge the battery pack included with your model.

Apply other decals if desired.

3. Install the antenna • See page 12

10. Drive your model • See page 18

The receiver antenna and antenna tube must be properly installed
before operating your model.

Driving tips and adjustments for your model.

4. Install batteries in the transmitter • See page 11

11. Maintaining your model • See page 25

The transmitter requires 4 AA alkaline or rechargeable batteries
(sold separately).

Follow these critical steps to maintain the performance
of your model and keep it in excellent running condition.

5. Install the battery pack • See page 12

Install the included battery pack in your model.

6. Turn on the radio system • See page 13

Make a habit of turning the transmitter on first and off last.

7. Check servo operation • See page 14

Make sure the steering servo is working correctly.

QUICK START: GETTING UP TO SPEED

Look for the Quick Start
logo at the bottom of
Quick Start pages.

The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your model.

Your model includes both
straight and 90-degree body
clips. The straight body
clips are intended for use
in the front body mounts.
The 90-degree body mounts
should be installed in the rear
body mounts, as shown in the
illustration below. This will
reduce body clip damage or
loss in a rollover.