Cadence ZRS C4 - Manual (Page 2)

When bridging the ZRS C4, minimum
impedance per channel is 4 ohm mono
bridged. When using DVC 2 ohm
woofers, voice coils must be wired in
series to 4 ohm.
Channels 1 and 2 to Front Left + Front
Right component speakers with channels
3 and 4 bridged to 4 ohm mono load.
Channels 3 and 4 can be bridged to one
4-Ohm mono woofer.
Two 2-Ohm woofers can be used for
Stereo bass on Channels 3 and 4.
Channels 1 and 2 to Front Left + Front Right
Component Speakers.
Channels 3 and 4 to Rear Left + Rear Right
Component Speakers, 6” x 9” Speakers or
6.5” Speakers. Minimum Impedance 2 ohms
per channel.
4-Channel
Configuration
Crossover
Midrange
Tweeter
Crossover
Midrange
Tweeter
4-Ohm
6x9 or 6.5” Speakers
Channels 3 and 4 Rear
Crossover
Midrange
Tweeter
Crossover
Midrange
Tweeter
3-Channel
Configuration
4-Ohm
Single Voice Coil
To amp +
To amp -
DVC 2-Ohm
Wired in Series
to 4-Ohm
Or
4-Ohm
Single Voice Coil
DVC 2-Ohm
Wired in Series
to 4-Ohm
To amp -
To amp +
Or
4-Ohm Bridged Mono
Configuration
Multi-Speaker
Configuration
2-Ohm
Stereo
Load
8-Ohm
Midrange
8-Ohm
Midrange
8-Ohm
Midrange
4-Ohm
Midrange
8-Ohm
Midrange
8-Ohm
Midrange
8-Ohm
Midrange
8-Ohm
Midrange
8-Ohm
Midrange
4-Ohm
Midrange
4-Ohm
Midrange
4-Ohm
Midrange
ZRS C4 ZRS C4
4-Ohm
Single Voice Coil
To amp +
To amp -
DVC 2-Ohm
Wired in Series
to 4-Ohm
Or
Crossover Crossover
Tweeter Tweeter Tweeter Tweeter
4-Ohm Tweeters in Parallel 4-Ohm Tweeters in Parallel
2-Ohm
Stereo
Load
Eight 8-Ohmspeakers installed in parallel or
Four 4-Ohm speakers installed in parallel.
Do not mix impedances and do not run amp
below 2 ohm stereo load per channel.