Toa WS-300 - Manual (Page 6)

WS LAVALIRE NOMENCLATURE
LAVALIER BATTERY INSERTION
1. Slide the battery compartment to the rear and hinge up-wards to expose
the battery.
2. Insert a 9V MN1604 (IEC 6 LR61) PP3 type alkaline battery, being sure to
observe the correct polarity as marked.
Note: Should the Red battery status Led Indicator go out during operation, this
indicates a flattened battery and should be changed .
8 9
ROTATING
BELT
CLIP
BATTERY
STATUS
INDICATOR
BATTERY/
CONTROL
HOUSING
AUDIO
INPUT
ANTENNA
LAPEL MICROPHONE
ON/OFF
SWITCH
AF GAIN ADJUST
CHANNEL SELECT
MIC/INSTRUMENT SWITCH
MICROPHONE CONNECTION
1. Connect small lapel-type microphone into the corresponding 3.5mm Top
Panel Socket.
2. Ensure that the Battery Compartment MIC/INST switch is set to
Mic position.
3. Clip the microphone to your clothing (normally Tie or Jacket Lapel). Route
the mic cable so as to avoid undue strain or friction. Try and keep the mic
cable away from the ANTENNA
The microphone supplied with the WS as a Omni-directional response,
which means it will pick up sounds from all directions. In view of this we
recommend that the microphone is placed as close as possible to the required
sound source.
LAVALIER GAIN CONTROL ADJUSTMENT. (Small screw-driver adjust)
If required adjust the Transmitter AF gain control so as the signal only very
occasionally allows the Red AF O/L Peak Led on the receiver to light.
CHANNEL NUMBER SETTING (Small screw-driver adjust)
With the Transmitter in the OFF position, select a channel to correspond with
the Receiver. It is possible to select any of the 4 channels.
(Factory set to position 1).
Note: The Transmitter only changes Active Channel when turned off and then on.
TOA instruction Manual ARTWORK_2 5/9/06 1:49 pm Page 11