Toa N-8510MS - Manual (Page 4)

8. WIRING
9. ACCESSORIES
CD* 2 .................................................. 1
Ferrite clamp ..................................... 1
* 2 Contains the N-8000 setting software program and the
N-8000 series instruction manual.
The Setup Launcher is automatically started when the
supplied CD-ROM is inserted into the PC's drive.
Note
If your PC's CD drive is not compatible with the
AutoRun function, the setup guide is not automatically
started even when the CD is inserted.
Use either "Explorer" or "My Computer" to execute the
following files, or use [Start
Run] in the Task Bar and
enter the following command.
\index.html
For example, when the CD is placed in the "d" drive,
d:\index.html
10. OPTIONAL PRODUCTS
AC adapter: AD-1210P* 3 , AD-1215P* 3
Wall mounting bracket: YC-280
* 3 Consult your TOA dealer when using an equivalent
adapter.
N-8510MS rear
[Network connection]
C a n b e c o n n e c t e d t o a n e t w o r k o f
10BASE-T/100BASE-TX in auto-sensing.
Use a UTP category 5 straight-through
cable with an RJ-45 connector for this
connection.
Note
W h e n u s i n g a P o E h u b , b e s u r e t o
connect equipment having a protective
earth terminal (or power cable with earth)
and ground the earth terminal. Failure to
do so may cause equipment malfunction.
[AC adapter connection]
Connect the AC adapter* 1 .
Install the supplied ferrite
clamp on the AC adapter
cable by winding the
cable around the ferrite
clamp once.
[Power supply connection]
The following 2 methods are available for
supplying power to the station.
• From a DC 12 V AC adapter
• From an IEEE802.3af compliant PoE
switching hub
(For connection, refer to the instruction
manual supplied with the switching hub.)
To network
11 mm
COM HOT
• Applicable cables are as follows.
Conductor diameter:
ø0.4 – 1.3 mm (AWG16 – 26), Solid wire
ø0.7 – 1.4 mm (AWG16 – 22), Stranded wire
[Control line connection]
Connect the external control equipment such
as a switch or sensor to this terminal.
Press down the desired push-in
terminal button with a tip of standard
driver, and insert the cable securely.
Cable
Ferrite clamp (accessory)
* 1 Use the AC adapter AD-1210P/1215P (optional) or
its equivalent.
As for the usable adapter, consult your TOA dealer.
DC INPUT CONTACT IN
C H
LAN
12V 400mA
133-06-295-1A
URL: http://www.toa.jp/
Traceability Information for Europe
Manufacturer:
TOA Corporation
7-2-1, Minatojima-Nakamachi, Chuo-ku, Kobe, Hyogo, Japan
Authorized representative:
TOA Electronics Europe GmbH
Suederstrasse 282, 20537 Hamburg, Germany