Toa N-8031MS - Manual (Page 4)

3.6. Terminal Station Connection
Mini-clamp connectors for line terminals and removable
terminal plugs for paging output terminal are supplied with
the N-8000EX/8010EX Exchange.
Perform each connector connection as follows.
Step 1. Cut off two-cable ends in equal length, and insert
them securely to a cover section (transparent
side) of the mini-clamp connector.
Note
Insert the cable without stripping the cable jacket.
Step 2. With a pair of pliers, lightly pinch the mini-clamp
cover and, after ensuring that the cable is
securely inserted, firmly squeeze on the cover.
Note
Squeeze on the mini-clamp cover until it is
correctly locked.
Cover
(transparent side)
Cable
Step 3. Insert the wired connector (plug) into the
exchange's connector (socket) until it locks into
place.
N-8000EX/8010EX Rear panel
3.7. Terminal Plug Connection
Step 1. Strip a cable jacket of approx. 5 mm from the
cable end.
5 mm
Note
Do not solder plate on exposed inner cables
when using a stranded wire.
Step 2. Loosen the terminal screws and insert the cables.
Step 3. Tighten the terminal screws securely.
Notes
• Tug lightly on the cable to be sure that it does
not pull free. If the cable pulls free, loosen the
terminal screw again and reconnect from Step
2.
• To avoid stripping the screws, use the
screwdriver appropriate to the screws tightened
into the terminal plug.
Step 4. Insert the wired terminal plug into the pin header
on the N-8031MS's PC board.
Removable terminal plug
(accessory)
N-8031MS's
PC board
Pin header
Cable
3
2
4
Tighten
1 2
133-06-268-9E
URL: http://www.toa.jp/