Tactic TTX850 8-Ch SLT Computer - Manual (Page 8)

8
USER NAME
Enter your name to identify the radio. The cursor will be under the fi rst character. Press ENTER to highlight
this character. Press
and to fi nd the desired character, then ENTER to confi rm. The cursor will
automatically move to the next cursor. Repeat as necessary for up to 11 characters. Pressing CLEAR will
move the cursor back one space and erase the character in that space. Press ESC when fi nished.
STICK MODE
The TTX850 is factory set to Mode 2 confi guration,
but can be changed to Mode 1, 3, or 4 as explained
below. To change modes in the programming, move
the cursor to the STICK MODE line, highlight and
press ENTER, then press
or to fi nd the
desired mode. Press ENTER to confi rm.
In addition to programming changes, stick mode changes require relocation of gimbal stick parts to achieve
the proper control. Go to www.tacticrc.com and click on the TTX850 link to fi nd directions for how to change
gimbal settings.
CONTRAST
Adjust the LCD’s contrast level for optimum viewing.
SPEAKER VOLUME
Adjust the loudness of the radio’s beeper as desired. This volume setting affects all tones that are emitted
from the radio including trim adjustments, alarms, programming changes, etc. Speaker volume for all alarms
is not adjustable.
BATTERY ALARM
An alarm will sound and the display will show a warning when the Tx battery’s voltage drops to the level
shown in this setting. Do NOT set this value too low, as the radio could lose power very rapidly as the
battery nears full discharge and cause a loss of control of the model. Land the model immediately once
this alarm has sounded!
VIBRATION POWER
Turn the vibration feedback ON or OFF.
BACK LIGHT
Adjust the intensity of the LCD’s red backlight.
Once all functions in this menu are set, press ESC to return to the home screen.
From the home screen, press and hold ENTER for 2 seconds to fi nd the MODEL SETUP menu for setting
of fundamental operating parameters as explained here.
MODEL SELECT
Memories are available to store parameters for up to 30 different models. With this selection highlighted
press ENTER. Press
or to move the cursor up/down the screen to fi nd the desired memory to make
active, and press ENTER twice to confi rm the selection and automatically return to the home screen. Or
press ESC to return to the home screen.
1
2
3
4
Mode
elevator/rudder
throttle/rudder
aileron/elevator
throttle/aileron
Left Stick
throttle/aileron
aileron/elevator
throttle/rudder
elevator/rudder
Right Stick
MODEL SETUP MENU – AIRPLANES