Accessory burners lighting, Using the grill light – Sure Heat 2008 Four Seasons FSIS User Manual
Page 13
Accessory Burners Lighting
ROTISSERIE LIGHTING
Open the lid. Push and turn the control knob for the rotisserie counter-clockwise to the “HIGH”
position.
Continue pushing on the knob and you’ll hear a snapping sound. If the burner does not light in 4
seconds, turn the control knob to "OFF" and wait 5 minutes before trying again. Once lit, turn the
control knob to the desired setting.
If the igniter does not function, the burner can be lit by holding a lit match to the burner while the
control knob is turned counter-clockwise to “HIGH”.
NOTE: After the first use the stainless steel around the burner will darken. This is a normal
reaction of premium stainless steel due to heat and is not a defect. The infrared panel will
also darken after initial use. This is also a normal occurrence.
NOTE: Do not operate the main burners and infrared back burner at the same time.
This can cause warping of the roll top grill hood.
▲
!
13
SIDE BURNER LIGHTING
Push and turn the control knob to the “HIGH” position. Continue pushing on the knob and you
will hear a snapping sound. It may be necessary to hold the electronic starter button for about 4
seconds. If the burner does not light in 4 seconds, turn the knob to the “OFF” position and wait 5
minutes before trying again.
MATCH LIGHTING
If by chance the electronic igniter does not light the burner, the burner may be lit with a match. Attach
the match to the match extender, located inside the right cart door.
Keep your face as far away from the grill surface as possible and hold a match, attached to the
match extender, near the burner ports, then push and turn the control knob counter-clockwise to the
“HIGH” position.
Using the Grill Light
▲
!
WARNING
Always unplug light cord when not in use.
▲
!
WARNING
Do Not use grill light in the rain.