Assembly instructions – Sunny Health & Fitness 059 User Manual
Page 4
.
Assembly Instructions
1. Take out the Base Frame (10) from the box
and lift both pedals all the way up.
2. Lift pedals up and push the pulley a little
forward to its place. Then hook the cable to the
groove of pulley (11) and press the pedals
down.
3. Tighten the Adjustment Knob (9) onto the
Base Frame (10). Use this Knob to adjust the
stepping height (tension).
4. Disconnect the Connecting Wire (1b) from the
Meter Wire (1a). For your convenience connect
the Connecting Wire (1b) with the twist tie that
came from the computer package. This way, you
can easily insert the Connecting Wire (1b)
through the Bottom Stand Post (7).
5. Pull out the Wire (1c) from the Base Frame
(10), and connect it with the Connecting Wire
(1b). Use the Allen Wrench (A), Washers (4)
and Bolts (8) to assemble the Bottom Stand
Post (7) onto the Base Frame (10).
6. Pull out the Connecting Wire (1b) from the
Bottom Stand Post (7).
7. Take the wire from the Meter (1a) and put it
through the small hole in the Top Stand Post (5).
You can also use the twist tie again, as men-
tioned in step 4; to insert the Meter wire (1a)
easily through the Top Stand Post (5).
3