Sunny Health & Fitness SF-E1114 - Manual (Page 7)

7
Step 3:
1. Tighten the swing tubes (28R/L) to handlebar post (17) with wave washers
(63), screws (55), spring washer (8) and flat washers (54).
*Note: do not screw it too tightly.
★ CAUTION: For next step: Part 43 is labeled L for LEFT and R for RIGHT.
Please make sure to turn 43L Counter clockwise and 43R clockwise.
The Right and Left Hinge Bolt (No. 43R/L) must
fully penetrate the nylon ring of the nylon nuts
(51R/L). This will ensure the stability and durability
of your Elliptical Trainer.
In order to install hinge bolt properly, keep it
perfectly straight as the bolt goes through the
pedal arms and the crank. If the hinge bolt is
connected to the crank at an angle, damage to
both the hinge and the crank may occur.
2. Tighten the pedal support tubes (41R/L) to the cranks (10R/L) with wave
washers (44) and bolt (43R). Attach spring washers (50) and nylon nuts (51R/L)
to the end of the bolts (43) Note: do not screw it too tightly.