Cadence Q DRIVE SERIES - Manual (Page 7)

Choose a convenient mounting location with unobstructed airflow.
The Q amplifiers feature four plastic mounting tabs located at the amplifiers four corners. You will need to remove
the light-up acrylic panel and the chrome trim plate to access these mounting tabs.
Using the supplied screws, gently mount the amplifier in to position. Do not over tighten the screws.
All Q series amplifiers come with three molded acrylic covers in
red, blue and orange. The cover is held down with four thumb
screws. The amplifier crossover and gain controls are located
under the cover. Please note that the length of the four thumb
screws are different, there are two short ones and two long ones.
The shorter screws are for the lower shelf of the acrylic cover,
while the longer screws fit the raised shelf area of the acrylic
cover.
There is an area of multiple white neon LED bulbs underneath
the cover which transmit the light through the cover. By simply
changing the cover you can change your amplifier installation
color to either blue, red or orange.
Please take special care not to scratch the surface of the acrylic
covers. Clean them only with a soft damp towel. The use of any
cleansers may scratch the surface and remove the silver
stamping of the logo.
Replacement covers and thumb screws are available from
Cadence.