Sound Oasis S-5000 - Manual (Page 10)

A-8
6. In the Set Alarm Sound Mode, SET ALM SOUND is displayed. To
select a specific sound to wake up to, press  or  until your
desired sound is displayed.
7. Within five seconds after selecting your alarm sound, you may
adjust the volume by rotating VOLUME CONTROL clockwise to
increase the volume or counterclockwise to lower the volume.
8. Press the respective SET 1 or SET 2 after selecting the SOUND
alarm to exit the Alarm Time, Sound and Volume Setting Mode.
Selecting the Alarm Output Sounds
1. To select the alarm output sound for Alarm 1, press SET 1 until
your choice of alarm type is visible on the lower and upper
display areas. ALARM 1 SOUND, ALARM 1 RADIO, ALARM 1 BEEP, or
ALARM 1 OFF will be visible on the upper part of the display as you
scroll through the options.
2. Press SET 2 and repeat Step 1 to select the Alarm 2 sound.
Note: The alarm volume will gradually increase in volume after
activating. If you are listening to a sound (e.g. white noise all night)
and the alarm sounds, the alarm will sound as a beeping alarm only to
ensure you hear the alarm.
Checking the Alarm
You may confirm your wake up alarm time, alarm sound and alarm
volume with ALARM CHECK. Press ALARM CHECK 1 or ALARM CHECK 2
to play back your selected alarm sound and display your alarm time on
the clock’s display
Note:
• The display shows CHECK ALARM 1 for Alarm 1 and CHECK ALARM
2 for Alarm 2.
• You can adjust the alarm sound volume during the alarm check
mode by rotating VOLUME CONTROL while the alarm sound is
playing back.
• Unless the alarm is turned off, the alarm will sound again in
24 hours at your set alarm time