Snazzy FX TIDAL WAVE - Manual (Page 10)

however when the ROUTING SWITCH IS FLIPPED DOWN, !
!
THE DRY SECTION FIRST CONNECTS TO THE VCF AND THEN THE VCF GOES
STRAIGHT INTO THE WAVE SECTION.!
!
THIS BOTTOM MODE IS WHAT YOU WOULD ALSO USE FOR SETTING UP THE
TIDAL WAVE AS A VOICE MODULE, AS THE VCF WOULD BE SET TO THE HIGH Q
MODE, a 1/v oct signal would be patched into the vcf, and then the wave folder would
manipulate the sine wave, and the whole thing would go into the VCA.!
!
SWITCHES SECTION!
!
16. ENV TRIG SOURCE SWITCH. this selects the trigger source for the ATTACK/
RELEASE env!
!
!
17. MIX SOURCE SWITCH (see VC MIX diagram) this determines which signals are
sent to the LEFT AND RIGHT sides of the VC MIX pot. CV or the internal LFO can
sweep thru the two signals, crossfading them.!
!
18. FEEDBACK SWITCH. DEFAULT IS OFF. see feedback diagram. BE CAREFUL
WITH THIS SWITCH! The feedback can be much louder than the normal signal and can
move into regions of non-linearity or instability very quickly. Very useful for creating
aggressive sounds, easy to turn on and turn off very quickly.!
!
19. CV BUS SWITCH!
!
!
20. LFO BUS SWITCH!
!
!
19 and 20 and JACK 22 (ws/cv bus) all interact, and all three control which CV sources
are sent around the module (to the WS MOD knob, the Q mod, and the FILT mod
sections AND the VC MIX section.!
!
To disable all internal CV, simply set both switches to their middle positions (OFF) !
to Send the Attack Release Envelope to Q MOD, the TRIANGLE wave out of the LFO to
the FILT MOD knob, and the Sine wave out of the LFO to the VC MIXER, simple set CV
BUS to bottom position and LFO BUS to the LEFT position. (CV BUS SWITCH ALWAYS
SENDS OPPOSITE SIDE OF SELECTION TO Q Mod and selection to FILT MOD)!
LFO BUS switch always sends LFO side (mix side sends selected wave to VC MIX) of
switch to the NORMAL of the WS/CV BUS JACK. THIS IS HOW WE GET CVS ALL
OVER THE MODULE!! IF YOU HOWEVER PLUG A CV INTO THE WS CV JACK,
THEN THAT CV IS WHAT WILL BE SENT when CV BUS is set to WS.!
!