SmarTek Systems SAS-1 Detailed Communication Formats - Manual (Page 8)

SmarTek Systems (www.smarteksys.com) 8
,,,,,,,,,,
,}
All parameters are bytes and are offset by +32 (20 Hex).
For SAS-1 software versions SAS_131 and above, the Send Parameters command not only
sends parameters to the SAS-1, but causes the parameters to be written to non-volatile
flash memory.
SAS-1 Response:
No Response.
Command to SAS-1: Set SAS Baud Rate
{SASxxxx,BAUD=Baud_Rate}
Baud_Rate is a byte and is offset by +32 (20 Hex).
Baud_Rate = 0 “2400 bps” This rate will not support TAI or RELAY operating modes.
1 “4800 bps” This rate will not support TAI or RELAY operating modes.
2 “9600 bps” This rate will not support support RELAY mode.
3 “19200 bps” This rate will not support RELAY mode.
4 “38400 bps”
5 “57600 bps”
6 “115200 bps”
SAS-1 Response:
Chr(2)OKChr(3) “OK” is ASCII.
Command to SAS-1: Save Parameters to SAS-1 NonVolatile Memory
{SASxxxx,WPRM}
SAS-1 Response:
Chr(2)OKChr(3) “OK” is ASCII.
For SAS-1 Software Revision SAS_131 or higher, this command has no effect.
Command to SAS-1: Get SAS-1 ID
{SAS0000,GETID}