Sevylor QuikPak K5 Kayak - Manual (Page 10)

INFLATABLE QUIKP
AK™ KA
YAKS
10
®
Installed
Seat
9. Turn seat over and set aside.
11. Inflate inner chamber to 0.9 PSI.
13. Take seat that was set aside in step 9, and
fold as shown.
14. Line up hook & loop strips on seat bottom with the hook & loop strips on the kayak floor. (See the
following image that show installed seat)
10. Unfold kayak and install detachable fin to
connectors on bottom, rear of kayak, by
hooking the fin tabs into the slots on
the connectors.
Note: Skip step 10 if model comes with
permanently attached fin.
12. Inflate outer chamber to 0.9 PSI.
Inflate Kayak (using order shown below)
Inner Chamber Valve
Outer
Chamber Valve
Seat Hook & Loop Strips
Kayak Hook &
Loop Strips
Seat Bottom
Seat
Back