Seville Classics EHF10127 - Manual (Page 4)

5
STEP 4
Run the power cord through the guide on the bottom of the BASE-back by tucking the
cord under the tabs. Set fan upright on the base and it is ready for use.
STEP 3
Pass the Power Cord through the center hole of the BASE.
Align the BASE front with the FAN front and insert the four posts on the FAN body into
the four holes on the top of the BASE. It will only go one way. Place the 4 Fan-Body
SCREWS into the holes through the bottom of the base and securely tighten.
6
ON/OFF: Turns fan ON & OFF
Speed Selection: Allows four different speed settings
Timing Selection: There are 15 settings, in 1/2 hour increments. Time
increases with each push of the button. 1/2 hour, 1 hour, 1-1/2, 2 hours etc. to
a maximum time setting of 7- 1/2 hours.
The LED Indicators on the control panel are marked 0.5h, 1h, 2h, 4h. (h for
Hour) The total of the lit LEDs is the total time period.
High Low Medium
D
D
D
D
D
Power Cord
See further instructions on use, care and safety.
ECO
Fan Assembly Control Panel
NOTE: In order for the speed to run efficiently, this speed begins at low, and then automatically drops to . ECO ECO
Push buttons to activate features
4h
2h
1h
0.5h ECO
R
C
B
A
C
B