Santec Thermax with TL - Manual (Page 3)

Rough installation
- Turn the water supplies off.
- Remove all the trim items (plate and handle) before
installation.
- Secure the valve firmly against the stub.
- Make sure that the shower out let is in the up position.
- Flush or raise grouting on the tiled wall surface.
- Connect the supply lines to the valve inlets.
-
The rough depth must fall within the minimum/
maximum range lines marked on the plaster guard.
- For both functional and esthetic reasons, the valve must
be leveled horizontally.
- When soldering the inlet connection, make sure that all
internal parts are removed to avoid damages to the non-
metal parts.
- If only the shower portion of the valve will be used, keep
the tub outlet plugged at all time.
-
M
a x
M
in
Finished wall
Minimum and
Maximum Lines
Trim installation
M
a x
M
in
1.
- Remove the screws from the plaster
guard.
- Remove the plaster guard.
PAGE 03 PAGE 04
1 0 5
1 0 5
1 0 0
1 0 0
9 5 9 5
Valve
cylinder
Trim
plate
Rubber
seal
Handle
base Handle
screw
Plate
screw
- After the plaster guard is taken off. Insert the valve cylinder into the valve.
Align it in to the proper slot.
Place silicone caulk around the valve cylinder and valve to secure.
- Slip the trim plate with the rubber seal into the cylinder. Make sure the place is
flushed against the wall.
- Screw the plate screws(2) to secure the plate against the wall.
- Align the 100F on the handle base against the blue line drawn on the valve.
- Secure the handle base against the valve stem with the handle screw.
Tighten firmly.
- Screw the handle cap onto the handle base.
2.
Handle cap
IF THE ACTUAL WATER TEMPERATURE IS DIFFERENT FROM THE DIAL
- If the actual water temperaturediffers from what is shown on the temperature dial.
1- Take the handle off.
2- Turn the water on through the volume control, measure the actual water
temperature with a regular thermometer.
3- Turn the dial until the thermometer shows 100F.
4- Remove the dial handle from the valve.
5- Align the 100F with the center mark
of the valve cylinder.
6- Insert the handle into the cartridge
7- Tighten the screw and insert the cap.
CENTER MARK
1 1 0
1 1 0
1 0 0
1 0 0
9 0 9 0
1 1 0
1 1 0
1 0 0
1 0 0
9 0 9 0