Santec YY-CU - Manual (Page 3)

PAGE 04
SANTEC LIFETIME LIMITED WARRANTY
1. Finishes: Santec Polished Chrome, Polished Nickel and Satin Nickel finishes carry a Lifetime
Limited warranty against manufacturing defects and tarnish to the original purchaser with the
exclusion of kitchen drain assemblies which, due to the nature of their use, are not warranted. Santec
recommended custom finishes carry a ten (10) years limited warranty against manufacturing
defects and tarnish to the original purchaser with the exclusion of kitchen and pop - up drain
assemblies w hich, due to the nature of their use, are not warranted.
2. Cartridges: Santec Cartridges carry a lifetime limited warranty against manufacturing defects for the
life of the product to the original purchaser.
3. Parts : Santec parts carry a Ten (10) year limited warranty against manufacturing defects, to the
original purchaser.
4. Warranty exclusions and limitations: This warranty does not cover: damage due to negligence,
accident, abuse, improper installation, or improper maintenance such as, but not limited to: heat from
soldering during installation, the use of plumbers putty, damage from tools used during installation,
the use or exposure to chemicals or cleaning products either abrasive or non abrasive or the use of
any cleaning tool or product other than a soft, clean cloth. This warranty does not cover: changes in
the finish or in the product due to normal wear or aging and does not cover any product or parts
which have been altered or used in a manner not typical for the product. This warranty does not
cover and Santec will not be held liable for damage to products caused by the freight carrier
and a claim should be made immediately to the freight carrier should this occur. This warranty
does not cover any cost involved in the installation, repair, or replacement of any Santec product or
part. This warranty does not cover and Santec will not be held liable for any loss, damages, or
expenses, incidental or consequential whatsoever, originating from the purchase, installation, use,
repair, failure, or replacement of any Santec product or part, as allowed by law. The product or
components of the covered product will either be repaired, refinished or replaced, at the sole
discretion of Santec. Santec reserves the right to examine any product claimed defective prior to
any warranty claim being accepted or processed, at its sole discretion. This warranty gives you
specific legal rights and you may have other rights which may vary from state to state.
Effective 10/01/03 - Replaces and supersedes any previously issued warranty.
FINISH CARE INFORMATION
For clear coated or enamel color finishes:
We recommend that all faucets, drains, etc. be
gently wiped dry with a soft cloth after use to avoid
water spotting and water deposit buildup. A mild
liquid hand soap, such as Ivory may be used
occasionally if desired. Use of a non-abrasive
carnauba wax will add protection to the finish and
should be used if the faucets will not be dried after
use. Santec Orobrass kitchen products are clear
coated.
For non-clear coated and specialty finishes:
We recommend that all faucets, drains, etc. be
gently wiped dry with a soft cloth after use to avoid
water spotting and water deposit buildup. Use of a
non-abrasive carnauba wax is required
occasionally.
Santec has obtained applicable code (standards) listings generally available on a national basis for products of this type.
It is the responsibility of the installer/owner to determine specific local code compliance prior to installation of the product.
Santec makes no representation or warranty regarding, and will not be responsiblefor any code compliance.
Some products listed in this catalog may not be approved for use in the state of Massachusetts, check with your Local Authority
or Licensed Plumber to assure code compliance.