Santec 9932CU-TM - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate on the all thread
- Secure the plate by inserting plastic washer and lock nut onto
all thread and make sure that the plate is secured..
- Thread the handle set with the washer and adapter onto all thread
with the stem and mark the position.
- Take off the handle assembly and cut off the excess thread and stem.
- Keeping the handle set at 6 o’clock position, thread handle assembly
onto all thread by using escutcheon being caution not to over tighten.
- Tightening the set screw using the allen key and insert the o-ring
and vent plug to cover the hole.
INSTALLATION INSTRUCTIONS
All Thread
Lock Nut
Lock Plate
LOCK NUT HANDLE ASSEMBLY
Trim Plate
Stem
PAGE 03
C OLD
WARM
WARMER
HOT
ILLUSTRATION C
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-007-1 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - Te012
Pressure Balanced Shower
PLASTIC WASHER