Santec 9970CR - Manual

KEEP THIS INSTRUCTION BOOKLET FOR FUTURE REFERENCE
PAGE 01
MINIMUM HOLE SIZE FOR THE SPOUT AND
HANDLE TRIM IS 1 ¼ ” AND MAXIMUM OF 1 ½ ”
*** NOTE: SHUT OFF WATER SUPPLY BEFORE BEGINNING INSTALLATION***
Black plastic lock nut
Trim Cylinder
Handle
Screw
Handle Cap
Black Soft Seating China Seals
Black Soft Seating China Seals
White Nylon Slip Washer
VACUUM BREAKER INSTALLA TION
- Remove complete trim from vacuum breaker valve.
Install bidet elbow into threaded outlet.
Insert gasket into bidet wye and thread onto bottom of vacuum breaker valve.
Remove black plastic lock nut, nylon slip washer and one black self-seating
china seal.
Insert diverter valve body up from below and reinstall black self-seating china seal,
nylon slip washer and black plastic lock nut being sure to tighten firmly by hand.
- Thread trim cylinder onto vacuum breaker valve and tighten firmly. Place handle on
top and secure with brass screw. Insert handle cap with arrow facing towards front
of bidet .
PLEASE READ THE INSTRUCTIONS COMPLETELY
BEFORE BEGINNING THE INSTALLATION.
DO NOT TIGHTEN
HOSE
DO NOT TIGHTEN
HOSE
B IDE T
COLLECTION
This is a general installation instruction
for the following collections:
* AVA
* AVA CRYSTAL