Santec 9235DC - Manual (Page 3)

TRIM INSTALLATION
- Place the shower plate on the all thread.
- Screw the handle flange onto the handle bell.
- Screw the handle bell with handle Flange and washer onto the all
thread. Press them firmly against the plate and mark the position.
Cut off the excess thread.
- Insert the Handle onto the stem. Measure the excess between
the handle bell and the handle. Take off the handle and cut the
excess stem.
- Reinsert the handle onto the stem. Using the Allen Key provided,
tighten the handle set screw firmly.
- Place the Trim Plate Grommet onto the designated hole for the
Diverter Rod on the Trim Plate.
- Screw the Diverter Knob onto the Diverter Rod.
INSTALLATION INSTRUCTIONS
PM-280 - SERVICE VALVE (OPTIONAL)
VALVE CARTRIDGE - TE010
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
PM-012 - LOCK NUT
PM-011 - ALL THREAD
FILTER SCREEN - TE012
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
PAGE 03
ILLUSTRATION C
FLANGE WASHER HANDLE FLANGE HANDLE BELL HANDLE
Trim Plate
CO LD
WARM
WARMER
HOT
Pressure Balanced Tub/Shower