Santec 9001P2 - Manual (Page 2)

- Take out the Lock Nut, washer and Nylon Sleeve from
the bottle P trap.
- Slide Locknut, washer and Nylon Sleeve on the drain
pipe as shown in the figure.(Sliding direction is shown by
the upward arrow)
- Drain pipe with Nylon sleeve to be inserted into the bottle
trap as shown by the downward arrow.
- Insert pop-up drain tube with plastic sleeve
into the bottle P trap unit and hand
tight the lock nut.
- Slide the nut on the horizontal tube.
Slide on the rubber washer on the horizontal tube.
- Hand tight the nut to secure the horizontal tube with
bottle P trap.
- Wall flange goes against the wall.
- Connect the horizontal tube to the
drain pipe through the wall.
W
a
ll
Dia. 1 & ¼ Inch
INSTALLATION INSTRUCTIONS
9001P2_ _
PAGE 02
INSTALLATION PROCEDURE
(1)
(2)
Rubber Washer
Washer
Lock Nut
Bottle P-Trap Nut for Horizontal Tube
Wall Flange
Nylon Sleeve