Santec 8465PU - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the pre-assembled toilet paper holder unit off the box.
Place the unit against the assigned wall location.
Make sure that the holder’s bar is leveled and the post position is correct.
Mark the holder post flange position and remove the unit.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware posts can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware posts can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimensions carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware posts by screwing the screws into
the wall.
3- Using the Allen key provided, loosen the holder post’s set screw.
Slip the holder post onto the mounting hardware post.
Secure the set screw by tightening the set screw with the Allen key.
4- Check the holder post to make sure it is firmly secured.
If not, tighten again the set screw with the Allen key.
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
8465PU _ _
WALL