Santec 8461PU - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the pre-assembled towel bar unit off the box.
Place the unit against the assigned wall location.
Make sure that the bar is leveled and the bar post positions are correct.
Mark the bar post flange positions and remove the unit.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware posts can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware posts can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimensions carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware posts by screwing the screws into
the wall.
3- Using the Allen key provided, loosen the bar posts’ set screws
Slip the posts onto the mounting hardware posts.
Secure both set screws by tightening the set screw.
4- Check both handle posts to make sure they are firmly secured.
If not, tighten the set screws with the Allen key.
P.S.: IF THE TOWEL BAR POST POSITION NEEDS TO BE ADJUSTED .
- The bar posts can be removed by unscrewing the screw underneath
the post base.
- Please note that only small space adjustment is allowed. Pre-set screw
marks on the bar may be shown if the space adjustment is too wide.
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
8461PU _ _
WALL