Santec 8266JU - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the robe hook off the box.
Place the robe hook against the assigned wall location.
Mark the robe hook flange position and remove the trim.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware post can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimension carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware post by screwing the screws into
the wall.
3- Using the Allen key provided, loosen the robe hook’s set screw.
Slip the robe hook onto the mounting hardware post and tighten
the set screw.
4- Check the robe hook to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
8266JU _ _