Santec 8068WT - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the TRIANGULAR wire soap dish off the box.
Place the unit against the assigned wall location.
REMEMBER THIS SOAP DISH FITS IN THE CORNER OF THE TWO WALLS,
WHICH ARE PERPENDICULAR TO EACH OTHER.
Mark the unit’s hole position.
2- Using the mounting hardware post as reference, mark the screw hole positions.
Make sure the two holes are horizontal and in line.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware post can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON SOLID/HARD SURFACE
- Measure the dimension carefully.
- Using a drill, pre-drill the holes.
- Secure the square wire soap dish by screwing the screws into
the wall through the holes..
3- firmly tighten all four screws.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
8068WT _ _