Santec 8068WR - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the square wire soap dish off the box.
Place the unit against the assigned wall location.
Mark the unit’s hole position.
2- Using the mounting hardware post as reference, mark the screw hole positions.
Make sure the two holes are horizontal and in line.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting hardware post can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON SOLID/HARD SURFACE
- Measure the dimension carefully.
- Using a drill, pre-drill the holes.
- Secure the square wire soap dish by screwing the screws into
the wall through the holes..
3- firmly tighten the two screws.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
05/03
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
8068WR _ _