Santec 708480 - Manual (Page 2)

Page 02
INSTALLATION INSTRUCTIONS
M ARKING
1. Mark the vertical distance of 22 and ½ inch on the wall.
This is the center distance between the two cylindrical
holders at the two ends of the slide bar.
2. Draw two circles having their center as two marked points.
3. Try to make them exact circles with defined centers,
insert screws through the four small holes in the pedestal.
4. Tighten them firmly.
A
SSEMBLY
1. Using the Allen key provided, loosen the bar posts’ set screws.
2. Slip the left bar post onto the left mounting hardware post.
3. Align the bar post and secure it by tightening the set screw.
4. Insert the slide bar onto the secured bar post.
5. Slip the right bar post with the washer onto the right
mounting hardware post.
6. Insert the right side of the slide bar into the right bar post.
7. Align the right bar post and tighten the set screw firmly.
8. Check both handle posts to make sure they are firmly
secured. If not, tighten the set screws with the Allen key.
9. Put on the Personal hand held spray assembly in the slotted
groove as shown in the figure.
COLLECTION
Slide bar with Personal Shower
22 ½”
φ
0.235”
3.596"
27.000"
Ø2.000"
57" long
0.725"
Water inlet