Santec 6129EC - Manual (Page 2)

INSTALLATION INSTRUCTIONS
COLLECTION
WALL MOUNT WIDESPREAD
SPOUT INSTALLATION
Screw in the wall mount quick connect into the nipple sticking out from the wall. Make sure
the back panel of the quick connect is flush against the wall.
Note. The length of the nipple sticking out of the wall must be between 3/8” - 1/2”
Remove the flow restrictor inside the quick connect by unscrewing the retainer.
Flush the line to remove any debris inside.
Reinstall the flow restrictor by screwing in the retainer.
Push the wall mount spout onto the quick connect until it is flush against the wall.
Using the allen key provided, tighten the wall mount spout set screw.
Quick Connect
Flow Restrictor Retainer
Set Screw
Flow Restrictor
Wall Mount Spout
Nipple
Wall
1
8
" 1
2
"
Page 02