Santec 4464CO - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the ring post with the ring off the box.
Place the trim parts against the assigned wall location.
Mark the ring post flange position and remove the trim.
2- Using the mounting hardware post as reference, mark the screw hole positions
in the center of the post flange mark on the wall.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting hardware post can be secured by
screwing the screws directly into the wall.
2b-
IF INSTALLING ON DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Insert the plugs into the wall.
- The mounting hardware post can be secured by screwing the screws
into the plugs.
2c- IF INSTALLING ON SOLID/HARD SURFACE
- Measure the dimension carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting hardware post by screwing the screws into
the wall.
3- Using the Allen key provided, loosen the ring post’s set screw.
Slip the ring post onto the mounting hardware post.
Align the ring post and secure it by tightening the set screw.
4- Check the ring post to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
07/06
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
WALL
4464CO _ _