Santec 4165BL - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the paper holder post off the box.
Place the post against the assigned wall location.
Make sure that the holder is leveled.
Mark the holder post position and remove the trim.
2- Using the Allen key provided, remove the mounting screw plates from
the holder posts.
Press the mounting screw plate holder against marked post position on the
wall and mark the screw hole positions.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting screw plates can be secured by
screwing the screws directly into the wall.
2b- INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting screw plate can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimensions carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting screw plate by screwing the screws into
the wall.
3- Press the holder post against the mounting screw plate.
Align the holder and secure it by tightening the set screw.
4- Check the holder post to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
07/04
WALL
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
post flange mark
mounting screw plate
4165BL _ _