Santec 4164BL - Manual (Page 2)

INSTALLATION INSTRUCTIONS
PAGE 02
1- Take the ring post with the ring off the box.
Place the trim parts against the assigned wall location.
Make sure that the ring is leveled.
Mark the ring post flange position and remove the trim.
2- Using the Allen key provided, remove the mounting screw plates from
the ring posts.
Press the mounting screw plate against ring post position on the
wall and mark the screw hole positions.
2a- INSTALLING ON WOODEN SURFACE
- For wooden surface, the mounting screw plates can be secured by
screwing the screws directly into the wall.
2b- INSTALLING ON A DRYWALL
- Using a drill, pre-drill holes for the toggles.
- Fold the toggle’s leg and insert it into the wall.
- The mounting screw plate can be secured by screwing the screws
into the toggles.
2c- IF INSTALLING ON A SOLID/HARD SURFACE
- Measure the dimensions carefully.
- Using a drill, pre-drill the holes.
- Secure the mounting screw plate by screwing the screws into
the wall.
3- Press the ring post against the mounting screw plate.
Align the ring post and secure it by tightening the set screw.
4- Check the ring post to make sure it is firmly secured.
If not, tighten the set screw with the Allen key.
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
07/04
WALL
WOODEN SURFACE
DRY WALL SURFACE
HARD SURFACE
post flange mark
mounting screw plate
4164BL _ _