Santec 3555TD - Manual (Page 3)

HOT WATER
SUPPLY
COLD WATER
SUPPLY
From Diverter
to Hand shower
4-Port
Diverter
FROM HOT VALVE TO DIVERTER
FROM DIVERTER TO SPOUT
FROM COLD VALVE TO DIVERTER
Cold Valve Hot Valve
Hand
Showe
r
Tu
b Sp
ou
t
Ho
t
Va
lve
Cold
Valve
IN
OUT
IN
O
UT
HAND SHOWER INSTALLATION
1
- Slip the guide tube, flange and the washer from the top of the tub through
the appropriate hole. Screw the mounting hardware from the bottom of the tub, first the
crimped metal washer then the brass lock nut. Tighten the lock nut firmly.
2
- Wrap Teflon seal tape around the threaded outlet end (OUT) of the diverter valve. Connect and
tighten the 1/2” female side of hose onto the outlet.
- Slip the other end of the hose (3/8”) up through the guide tube , connect and tighten the
hose to the hand shower unit.
WATER TEST
- Turn on the cold water supply.
- Use the handle from the faucet set to turn the valve on and off.
- Check for leaks. If water leaks from any of the connections merely tighten the connections
until the leak stops.
- Repeat the same procedure for the hot side.
Metal washer
Brass lock nut
Rubber washer
Diverter
PAGE 03
Santec Inc.
3501 Challenger Street, Torrance, CA 90503
Tel: (310) 542-0063 Fax (310) 542-5681
www.santecfaucet.com
03/03
INSTALLATION INSTRUCTIONS
3555TD _ _